Powering And Initial Circuit Pack Installation; Description - Alcatel-Lucent 1665 Installation Manual

Powering and initial circuit pack installation

............................................................................................................................................................................................................................................................

Description

Overview
This section should be performed on all shelf installations.
Tools, test equipment and accessories
Listed below are the tools, test equipment and accessories necessary to perform the
procedures in this section.
Quantity
1
1
1
1
1
1
............................................................................................................................................................................................................................................................
2 - 2
Description Comments
Screwdriver(s) A screwdriver(s) with the appropriate head(s) is (are)
required for securing the mounting screws,
repositioning the mounting brackets, installing the
interfacing cables, and for setting the circuit breakers
to the OFF position.
ESD Wrist Strap A wrist strap must be worn when handling circuit
packs. Use the electrostatic discharge (ESD) jack
provided on the shelf.
Multimeter The voltmeter must be capable of measuring DC
(Optional) voltage in the 40- to 60-volt range. The use of the
voltmeter is optional since the shelf will alarm or
shut down if the proper voltage is not supplied.
Personal Required to run the WaveStar
Computer (PC) minimum requirements (p.
CIT Interface 8-ft. long RJ45 to 9-pin D-sub serial cable (Comcode
Cable 848748869). Required to connect the PC to the CIT
jack on the front of the SYSCTL circuit pack.
LAN 10BaseT As required to reach from front of Alcatel-Lucent
Cross-over Cable 1665 DMX to the PC
CAT 5 or better
®
CIT software. See PC
3-2).
365-372-304R7.1
Issue 2 March 2008
Description