Alcatel-Lucent 1665 Installation Manual page 299

WDMX setup and testing: integration procedures
............................................................................................................................................................................................................................................................
Result:
........................................................................................................................................................................................................................
15
Repeat
........................................................................................................................................................................................................................
16
Remove fiber and LBOs from Port 9 of both LNW705s.
........................................................................................................................................................................................................................
17
Establish the end to end link on the 10G PTM while observing the proper optical levels
listed in
connecting through the LNW785 go to
LNW785" (p.
........................................................................................................................................................................................................................
18
Locate and connect the span fibers to the LNW705 while observing the proper optical
levels listed in
(p. 7-20).
........................................................................................................................................................................................................................
19
Repeat
........................................................................................................................................................................................................................
20
Observe test set and verify error-free transmission. If only one test set is available, connect
a fiber from the In port to the Out port of the PTM in port 1 at one end. Use the
information listed in
(p. 7-20)
Note:
customer.
........................................................................................................................................................................................................................
21
Disconnect test set(s) and fiber jumper from ports.
........................................................................................................................................................................................................................
22
Remove PTM from LNW705 if necessary and clear any associated alarms by Selecting
Configuration ->Update System->Update Inventory.
........................................................................................................................................................................................................................
23
Check off the appropriate box in
E O
N D
........................................................................................................................................................
............................................................................................................................................................................................................................................................
365-372-304R7.1
Issue 2 March 2008
Test set reports the error.
Step 1 to Step 14 at the other node.
Table 7-3, "Attenuation table (Pluggable Transmission Modules)" (p.
7-10), otherwise continue.
Table 7-3, "Attenuation table (Pluggable Transmission Modules)"
Step 18 at the LNW705 at the other node on the opposite end of the span.
Table 7-3, "Attenuation table (Pluggable Transmission Modules)"
to determine the proper LBO/Attenuator.
Test duration may be determined by engineering specification or by the end
S
F T E P S
Procedure , "Integrating the LNW705 into the
Appendix E, "Installation checklist"
Turn up and test the LNW705 muxponder
7-20). If
7 - 9