Installation tests
............................................................................................................................................................................................................................................................
........................................................................................................................................................................................................................
4
Connect a cable from the DS3 test set transmit connection to the IN jack of the DSX-3
associated with the first DS3 or TMUX tributary of the Alcatel-Lucent 1665 DMX
Function unit slot to be tested.
........................................................................................................................................................................................................................
5
Connect a cable from the DS3 test set receive connection to the OUT jack of the DSX-3
associated with the first DS3 or TMUX tributary of the Alcatel-Lucent 1665 DMX
Function unit slot to be tested.
Result:
verify that the port on the DS3 or TMUX pack is receiving the signal, verify that the
port has transitioned to an "in service" state with the View -> Equipment command.
A port state of "IS" indicates that the pack is receiving a good signal to the port.
........................................................................................................................................................................................................................
6
While observing the error-free transmission at the DSX, grasp the DS3 cable about two
inches from the BNC connector head and gently rotate (twist) the cable in a clockwise and
counter clockwise direction about 45 degrees (gently).
Result:
connector must be cut off and replaced.
If an error-free signal is not received:
Check the LBOs settings using the
•
DS3/EC1 and TMUX LBOs (p.
Verify that the pack is provisioned for the framing format being sent from the test set,
•
M13.
Verify that the port is provisioned for DS3. See
•
Check the DS3/EC1 cabling for proper connections.
•
........................................................................................................................................................................................................................
7
Check off the appropriate box in
E
O
N D
........................................................................................................................................................
............................................................................................................................................................................................................................................................
4 - 2 8
The DS3 test set should indicate it is receiving an error-free PRBS signal. To
If any errors are detected while performing this "wiggle test," the BNC
S
F
T E P S
View -> Equipment
4-6).
Verify provisioning (p.
Appendix E, "Installation
DS3/EC1 and TMUX testing procedure
command (see
Setting
4-23).
checklist".
365-372-304R7.1
Issue 2 March 2008