Alcatel-Lucent 1665 Installation Manual page 298

WDMX setup and testing: integration procedures
............................................................................................................................................................................................................................................................
........................................................................................................................................................................................................................
5
Provision the PTM/OTU-2
Select Configuration --> Equipment from the System View
........................................................................................................................................................................................................................
6
Click the "+" next to XM10G/8 circuit pack to expand the list.
........................................................................................................................................................................................................................
7
Highlight the PTM sc9 and click Select.
........................................................................................................................................................................................................................
8
Enter the Frequency in the Expected Frequency and click Apply.
Note:
column in
........................................................................................................................................................................................................................
9
Highlight the Port 1 and click Select.
........................................................................................................................................................................................................................
10
Set the Signal type to match the PTM type, using the pull down window (for example if
the PTM is a
........................................................................................................................................................................................................................
11
Perform a single node self test by connecting an OC48 test set to Port 1, while observing
the proper optical power levels and cleaning procedures.
Insert a 15 dB LBO into the input of Port 9 and connect a fiber from the output of Port 9 to
the input of Port 9.
........................................................................................................................................................................................................................
12
Connect an OC-48 test set to the PTM in port 1 while observing the proper optical power
levels listed in
(p. 7-20).
........................................................................................................................................................................................................................
13
Condition the test set to transmit and receive a STS-48 PRBS test signal.
Result:
........................................................................................................................................................................................................................
14
Inject a single error from the test set.
............................................................................................................................................................................................................................................................
7 - 8
The frequency is determined by the PTM inserted in Port 9. See the LNW705
Table 7-1, "Channel/port assignments" (p. 7-18)
OC48SR1-I1, set the Signal Type to OC48) and click Apply.
Table 7-3, "Attenuation table (Pluggable Transmission Modules)"
Observe error-Free Transmission.
Turn up and test the LNW705 muxponder
for acceptable values.
Issue 2 March 2008
365-372-304R7.1