Alcatel-Lucent 1665 Installation Manual page 148

Powering and initial circuit pack installation
............................................................................................................................................................................................................................................................
........................................................................................................................................................................................................................
5
Install pluggable transmission modules (PTM) (p. 2-33)
........................................................................................................................................................................................................................
6
Check off the appropriate box in
E O
N D
........................................................................................................................................................
LNW6(28DS1), LNW7(28DS1PM), LNW8(56DS1E1) low-speed installation (optional)
Follow this procedure only if installing LNW6 (28DS1), LNW7 (28DS1PM), or LNW8
(56DS1E1) circuit packs into the Alcatel-Lucent 1665 DMX High-Capacity shelf.
Note:
circuit packs.
........................................................................................................................................................................................................................
1
Refer to the engineering job specification. Identify the proper function group slots where
LNW6, LNW7, or LNW8 circuit packs will be installed.
........................................................................................................................................................................................................................
2
Remove the LNW6, LNW7, or LNW8 from the packing material.
........................................................................................................................................................................................................................
3
Place the circuit pack into the shelf (slot A1, B1, C1 or D1 as required). Do NOT engage
the circuit pack in the backplane connector.
........................................................................................................................................................................................................................
4
If a protection circuit pack is required, continue with
pack into the protection circuit pack slot (A2, B2, C2 or D2 as required), then proceed to
Step 7.
Important!
for cooling.
........................................................................................................................................................................................................................
5
Remove the second LNW6, LNW7, or LNW8 from the packing material.
........................................................................................................................................................................................................................
6
Place the circuit pack into the shelf (slot A2, B2, C2, or D2 as required). Do NOT engage
the circuit pack in the backplane connector.
............................................................................................................................................................................................................................................................
2 - 2 0
S
F T E P S
LNW6 and LNW7 are not supported with LNW59 and LNW82 (VLF) main
Blank circuit packs are required in all unused slots to provide proper air flow
Appendix E, "Installation
Step
Initial circuit pack installation
checklist".
5. If not, install a blank circuit
365-372-304R7.1
Issue 2 March 2008