Alcatel-Lucent 1665 Installation Manual page 234

Installation tests
............................................................................................................................................................................................................................................................
........................................................................................................................................................................................................................
11
Select Configuration -> Update System... -> Update All.
Requirement: The flashing FAULT LED should extinguish on the OC-12 OLIU.
There should be no alarm indications on the Alcatel-Lucent 1665 DMX shelf.
........................................................................................................................................................................................................................
12
Remove the 15-dB LBO from the OC-12 OLIU (Port 2).
........................................................................................................................................................................................................................
13
Replace all protective dust covers on the OC-12 OLIU connectors, that were removed to
perform this procedure.
........................................................................................................................................................................................................................
14
Repeat this entire procedure for each OC-12 OLIU in the Alcatel-Lucent 1665 DMX
shelf.
........................................................................................................................................................................................................................
15
Check off the appropriate box in
E O
N D
........................................................................................................................................................
OC-12 facility loopback testing
Facility Loopback testing allows the installer to verify cabling to the OC-12 equipment.
This test is only required if the Alcatel-Lucent 1665 DMX shelf is connected to OC-12
equipment. If the shelf is NOT connected to OC-12 equipment, skip this section and
continue to the section on
Note:
necessary for the testing.
The Function unit slot under test must contain a OC-12 (LNW46) circuit pack in order to
perform this test.
........................................................................................................................................................................................................................
1
Log on to the Alcatel-Lucent 1665 DMX shelf using the CIT software as described in the
Chapter 3, "Software download and circuit pack
software" (p.
........................................................................................................................................................................................................................
2
Select Configuration -> Cross-Connections...
............................................................................................................................................................................................................................................................
4 - 5 0
S
F T E P S
OC-48 low-speed testing procedure (p.
An optical test set with the capability to transmit OC-12 SONET levels are
3-9).
Appendix E, "Installation
installation",
OC-12 (low-speed) testing
checklist".
4-53).
®
"Use of WaveStar
365-372-304R7.1
Issue 2 March 2008
CIT