Alcatel-Lucent 1665 Installation Manual page 190

Installation tests
............................................................................................................................................................................................................................................................
........................................................................................................................................................................................................................
7
Repeat
populated with DS1 circuit packs.
........................................................................................................................................................................................................................
8
Check off the appropriate box in
E O
N D
........................................................................................................................................................
Setting DS3/EC1 and TMUX LBOs
The DS3/EC1 and TMUX cabling will be tested with all ports provisioned for DS3. Set
DS3 LBO values as follows.
........................................................................................................................................................................................................................
1
Refer to the following table of cable lengths and LBO values. Determine the LBO value
corresponding to the DS3 (TMUX) cables installed:
Table 4-1 Cable lengths (feet)
LBO Value
IN
OUT
........................................................................................................................................................................................................................
2
From the CIT GUI, select Configuration -> Equipment...
........................................................................................................................................................................................................................
3
Select the desired DS3 port by clicking the + sign next to the CP.
........................................................................................................................................................................................................................
4
Highlight the port and click Select.
........................................................................................................................................................................................................................
5
Next to Line Build Out: choose the LBO value determined in
........................................................................................................................................................................................................................
6
Repeat
with DS3 or TMUX circuit packs.
............................................................................................................................................................................................................................................................
4 - 6
Step 2 through Step 6
S
F T E P S
734D
0 - 225
225-450
Step 1 through Step 5
for all DS1 ports in all function unit slots which are
Appendix E, "Installation
735A
0-125
125-250
for all DS3 ports in all function unit slots that are populated
LBO software settings
checklist".
Step 1.
365-372-304R7.1
Issue 2 March 2008