Alcatel-Lucent 1665 Installation Manual page 303

WDMX setup and testing: integration procedures
............................................................................................................................................................................................................................................................
........................................................................................................................................................................................................................
7
Set the Signal type to match the PTM type, using the pull down window (for example if
the PTM is a OC48SR1-I1, set the Signal Type to OC48) and click Apply.
........................................................................................................................................................................................................................
8
Connect the fibers from Main 1/Main2 to the PTM in the LNW705 while observing proper
optical levels, fiber cleaning procedures and fiber routing in the shelf.
........................................................................................................................................................................................................................
9
Repeat
Result:
alarms cleared between the nodes.
........................................................................................................................................................................................................................
10
If configuring the other direction, repeat
........................................................................................................................................................................................................................
11
Check off the appropriate box in
E O
N D
........................................................................................................................................................
LNW785/OC192
The LNW785 span is established and tested using the
LNW785 8 channel OMD" (p.
to the WDMX circuit pack. Main 1 is always referred to as the West direction, while Main
2 is the East
........................................................................................................................................................................................................................
1
Determine the direction of the Span, Main 1 or Main 2.
........................................................................................................................................................................................................................
2
Install an OC-192 PTM in the assigned port slot in the Main circuit pack
"Channel/port assignments" (p.
Note:
X10G52C5 through X10G55C5.
........................................................................................................................................................................................................................
3
Login to the Alcatel-Lucent 1665 DMX using the WaveStar
............................................................................................................................................................................................................................................................
365-372-304R7.1
Issue 2 March 2008
Step 1 to Step 8 at the other end of the circuit.
Once both ends are completed the Mains should go into service and LOS
S
F T E P S
Only the first 4 wavelengths can be used in the LNW59 and LNW502, PTMs
Step 1 to Step
Appendix E, "Installation checklist"
7-4). In some instances, only one direction may be added
7-18).
Connecting the ring (Mains) to the WDMX
9.
Procedure , "Turn-up and test the
seeTable 7-1,
®
CIT.
7 - 1 3