Alcatel-Lucent 1665 Installation Manual page 155

Powering and initial circuit pack installation
............................................................................................................................................................................................................................................................
LNW66 (10/100T) or LNW71 (10/100-PL) installation (optional)
Follow this procedure only if installing LNW66 (10/100T) or LNW71 (10/100-PL) circuit
packs into the Alcatel-Lucent 1665 DMX shelf.
........................................................................................................................................................................................................................
1
Refer to the engineering job specification. Identify the proper function group slot (A1, B1,
C1 or D1) where the LNW66 or LNW71 circuit pack will be installed.
Note:
function group.
........................................................................................................................................................................................................................
2
Remove the LNW66 or LNW71 from the packing material.
........................................................................................................................................................................................................................
3
Place the circuit pack into the shelf (slot A1, B1, C1 or D1 as required). Do NOT engage
the circuit pack in the backplane connector.
........................................................................................................................................................................................................................
4
Install a blank circuit pack into the companion circuit pack slot (A2, B2, C2 or D2 as
required).
Important!
for cooling.
........................................................................................................................................................................................................................
5
Repeat
with LNW66 or LNW71 circuit packs.
........................................................................................................................................................................................................................
6
Check off the appropriate box in
E O
N D
........................................................................................................................................................
............................................................................................................................................................................................................................................................
365-372-304R7.1
Issue 2 March 2008
The LNW66 or LNW71 circuit pack can only be installed in slot 1 of any
Blank circuit packs are required in all unused slots to provide proper air flow
Step 1 through Step 4
S
F T E P S
for each additional function group slot 1's to be equipped
Appendix E, "Installation
Initial circuit pack installation
checklist".
2 - 2 7