Use Of Wavestar ® Cit Software - Alcatel-Lucent 1665 Installation Manual

Software download and circuit pack installation
............................................................................................................................................................................................................................................................
Use of WaveStar
Description
Complete the following steps to login to the Alcatel-Lucent 1665 DMX via WaveStar
CIT. It is assumed that the CIT software has been installed on the PC and the NE software
has been downloaded to the Alcatel-Lucent 1665 DMX shelf per the Software Release
Description. See
Login procedure
........................................................................................................................................................................................................................
1
Connect the PC Serial cable to the RS232 (Serial) jack on the front of the SYSCTL circuit
pack. Or connect a PC LAN cable (cross-over) to the LAN (OSI) connector on the front of
the SYSCTL circuit pack.
Note:
Otherwise, you may experience login problems. To assign an IP address, start the DOS
prompt on the computer, and type the command ipconfig/all. The command will show
an IP address line. If there is no address line or 0.0.0.0 for an IP address, then you must
assign an IP address to the NIC card of the computer.
........................................................................................................................................................................................................................
2
Start the WaveStar
was created by the installation procedure.
........................................................................................................................................................................................................................
3
Enter the following in the Login window:
User ID:
Password:
Note:
disabled during installation.
........................................................................................................................................................................................................................
4
Click
OK
........................................................................................................................................................................................................................
5
After reading the Legal Notice, click
............................................................................................................................................................................................................................................................
365-372-304R7.1
Issue 2 March 2008
®
CIT software
Software installation (p.
An IP address must be assigned to the NIC card on the PC or laptop.
®
CIT software on the PC by double clicking on the WaveStar
LUC01
LUC+01
The login and password may not be required to login to the WaveStar
to connect.
3-4).
.
OK
®
Use of WaveStar CIT software
®
®
icon that
®
CIT if
3 - 9