Alcatel-Lucent 1665 Installation Manual page 34

Equipment and cable installation
............................................................................................................................................................................................................................................................
service (LNW19/19B/LNW20). Each DS3 Cable Assembly consists of two separate cable
groups, both containing 735A cables. One cable consists of 24 inputs and the other cable
consists of 24 outputs.
6. One cable is required for channels 1 through 12 and another for channels 13 through 24
(LNW66 and LNW71). LNW74 provides only ports 1 through 16.
7. When cabling the Alcatel-Lucent 1665 DMX High-Capacity shelf for office alarm
applications, one Office Alarm Cable Assembly is required for the bottom Alcatel-Lucent
1665 DMX shelf in a bay frame. One Office Alarm Mult Cable Assembly is required for each
additional Alcatel-Lucent 1665 DMX shelf in the bay frame.
For example, if four Alcatel-Lucent 1665 DMX shelves are located in a single 7-foot bay
frame, one Office Alarm Cable Assembly and three Office Alarm Mult Cable Assemblies are
required.
8. One misc. discrete cable per shelf as required.
9. These cables are used for IAO LAN (OSI/TCP-IP)/Front LAN (OSI/TCP-IP) connection (J16
and Front LAN port). LAN 10BaseT cross over cable should be used if the shelf is directly
connected to a PC and LAN 10BaseT straight through cable should be used if shelf is
connected to a hub.
10. Two cables per shelf for Ref1 and Ref2.
11. RS232 modem cable (RJ45 to 25-pin).
............................................................................................................................................................................................................................................................
1 - 6
Planning
365-372-304R7.1
Issue 2 March 2008