Alcatel-Lucent 1665 Installation Manual page 161

Powering and initial circuit pack installation
............................................................................................................................................................................................................................................................
........................................................................................................................................................................................................................
4
Check off the appropriate box in
E O
N D
........................................................................................................................................................
Install pluggable transmission modules (PTM)
This section contains the instructions for the installation of the pluggable transmission
modules.
........................................................................................................................................................................................................................
1
Refer to the engineering job specification. Identify the proper circuit pack type and the
port socket being equipped with the pluggable module. Make sure the transmission rate
(OC-3, OC-12, 100Base Ethernet GbE, FICON) matches the rate of the PTM See
Appendix G, "Pluggable transmission module
Note:
maintain cleanliness during storage and/or transportation. It is recommended that the
dust plug be kept in place to maintain cleanliness. With proper care and handling,
cleaning the pluggable modules should not be necessary.
........................................................................................................................................................................................................................
2
Check the ports for cleanliness and clean the pluggable module if necessary. See
Appendix B, "Fiber
........................................................................................................................................................................................................................
3
Insert the pluggable module in the required socket of the circuit pack faceplate, then
wiggle the module to verify that it is locked in the socket. See
transmission module
plugs.
Note:
Guidelines" (p. 2-34)
........................................................................................................................................................................................................................
4
Repeat
............................................................................................................................................................................................................................................................
365-372-304R7.1
Issue 2 March 2008
S
F T E P S
Pluggable modules are shipped with a dust plug installed into the ports to
cleaning".
CAUTION
Never mechanically clean the receive (RX) port. Air blows only should be used
on the receive (RX) port. The receive (RX) port contains a lens for focusing a
wide input. The lens is more easily scratched than cleaned.
installation". Verify that all unused sockets are equipped with dust
If installing PTMs in a LNW705, refer to
for installation guidelines.
Step 1 through Step 3
Appendix E, "Installation
installation".
if more modules need to be installed.
Initial circuit pack installation
checklist".
Appendix G, "Pluggable
Table 2-9, "XM10G/8 PTM Port
2 - 3 3