Alcatel-Lucent 1665 Installation Manual page 150

Powering and initial circuit pack installation
............................................................................................................................................................................................................................................................
........................................................................................................................................................................................................................
6
Place the circuit pack into the shelf (slot A2, B2, C2, D2 or G2 as required). Do NOT
engage the circuit pack in the backplane connector.
Note:
LNW18, LNW19 and LNW19B are not allowed in G1, G2.
........................................................................................................................................................................................................................
7
Repeat
LNW16, LNW18, LNW19, LNW19B or LNW20 circuit packs.
........................................................................................................................................................................................................................
8
Check off the appropriate box in
E O
N D
........................................................................................................................................................
LNW36 (OC-3 OLIU) low-speed installation (optional)
Follow this procedure only if installing LNW36 (OC-3 OLIU) circuit packs into the
Alcatel-Lucent 1665 DMX shelf.
Note:
replaced with LNW37 and vice versa as long as the PTM optics in the LNW37 are
compatible with the optical span.
........................................................................................................................................................................................................................
1
Refer to the engineering job specification. Identify the proper function group(s) and/or
growth slot(s) where LNW36 circuit pack will be installed.
........................................................................................................................................................................................................................
2
Remove the LNW36 from the packing material.
........................................................................................................................................................................................................................
3
Place the circuit pack into the shelf (slot A1, B1, C1, D1 or G1 as required). Do NOT
engage the circuit pack in the backplane connector.
Note:
slots A2, B2, C2, D2, G2. Always consult the engineering job specification for
placement of circuit packs.
............................................................................................................................................................................................................................................................
2 - 2 2
The LNW20 is allowed in G1, G2 when used in portless mode. LNW16,
Step 1 through Step 6
S
F T E P S
LNW36 and LNW37 may be used as a protection pair. LNW36 may be
If using LNW59 or LNW82 (VLF) mains, the circuit pack may be installed in
for each additional function group to be equipped with
Appendix E, "Installation
Initial circuit pack installation
checklist".
365-372-304R7.1
Issue 2 March 2008