Equipment and cable installation
............................................................................................................................................................................................................................................................
........................................................................................................................................................................................................................
4
Spin the spool until the peg on its back fits into the smaller hole on the arm of the bracket.
This will keep the spool from spinning any further.
........................................................................................................................................................................................................................
5
Push the pin until it is completely fastened.
........................................................................................................................................................................................................................
6
Repeat
........................................................................................................................................................................................................................
7
Attach one fiber radius control module to the bottom of each bracket, as shown:
............................................................................................................................................................................................................................................................
1 - 2 8
Step 3
through
Step 5
for all the spools, with three per bracket.
Fiber management installation (optional)
Issue 2 March 2008
365-372-304R7.1