Alcatel-Lucent 1665 Installation Manual page 158

Powering and initial circuit pack installation
............................................................................................................................................................................................................................................................
........................................................................................................................................................................................................................
6
Check off the appropriate box in
E O
N D
........................................................................................................................................................
LNW68 (1G LX) installation (optional)
Follow this procedure only if installing LNW68 (1G LX) circuit packs into the shelf.
Note:
........................................................................................................................................................................................................................
1
Refer to the engineering job specification. Identify the proper function group slot (A1, A2,
B1, B2, C1, C2, D1, D2) and/or growth slot (G1, G2) where the LNW68 circuit pack will
be installed.
Note:
packs can only be installed in slot 1 of any function group or growth slot 1.
........................................................................................................................................................................................................................
2
Remove the LNW68 from the packing material.
........................................................................................................................................................................................................................
3
Place the circuit pack into the shelf function group slot as required. Do NOT engage the
circuit pack in the backplane connector.
........................................................................................................................................................................................................................
4
Install a blank circuit pack into the companion circuit pack slot as required.
Important!
for cooling.
........................................................................................................................................................................................................................
5
Repeat
equipped with or LNW68 circuit packs.
........................................................................................................................................................................................................................
6
Check off the appropriate box in
E O
N D
........................................................................................................................................................
............................................................................................................................................................................................................................................................
2 - 3 0
S
F T E P S
The LNW68 (1G LX) requires single-mode fiber.
Unless equipped with LNW59 or LNW82 VLF mains, the LNW68 circuit
Blank circuit packs are required in all unused slots to provide proper air flow
Step 1 through Step 4
S
F T E P S
Appendix E, "Installation
for each additional function group and/or growth slot to be
Appendix E, "Installation
Initial circuit pack installation
checklist".
checklist".
365-372-304R7.1
Issue 2 March 2008