............................................................................................................................................................................................................................................................

Select and/or modify the following parameters:

1. Select the Port Aid: (lan-1 [front] or lan-2 [rear]) being provisioned.

Note:

function from LAN-1 unless the engineering specification calls for it. If the OSI

function is disabled, the only access to the shelf may be through the Serial Port.

2. If applicable, one at time, click the Modify button to set the IP Address and IP

Subnet Mask of the desired LAN port and the IP Default Router Address, if

connecting to a default router.

When the provisioning window opens for the IP address being provisioned, enter the

IP address as four dot-separated decimal numbers ranging from 0 to 255. Click OK to

make your changes or Cancel to quit.

3. Select Enable to enable the TCP/IP function, or Disable to disable the TCP/IP

function.

Note:

appears: Input, Data Not Valid, each IAO LAN Port must have a unique IP subnet

mask.

Scroll through the Port AID drop-down menu and identify the duplication, then assign

correct addresses as necessary.

Note:

command when requested, the system may reset and you will be logged off the system.

Selecting Disable allows you to stay logged on to the system to perform more

provisioning. You can then come back to this window and enable the TCP/IP function.

Note:

revert to January 1, 1970 (70-01-01) at midnight (00:00:00). If automatic

synchronization is unsuccessful from the network, the date and time must be reset

manually.

Click Apply at the bottom of the window to make your changes.

Result:

Click Yes to execute the command

365-372-304R7.1

Issue 2 March 2008

When provisioning TCP/IP on the Network Element, do not disable the OSI

If you enter duplicate IP addresses and/or IP subnet addresses, a warning

If you select Enable and click OK to apply any changes, then execute the

Following a Alcatel-Lucent 1665 DMX system reset, the date and time may

A warning window opens and asks if you want to execute this command.

Provision/enable/disable TCP/IP on an IAO LAN port

3 - 1 5

Table of Contents

Show Quick Links

Hide quick links:

Table of Contents

Alcatel-Lucent 1665 Installation Manual page 179

Hide quick links:

Related Manuals for Alcatel-Lucent 1665

Related Products for Alcatel-Lucent 1665

Table of Contents