Removing The Front Handle - IBM NeXtScale nx360 M4 Installation And Service Manual

Figure 34. Filler installation
5. Reinstall the cover (see "Installing the compute node cover" on page 111).
6. Slide the compute node into the rack.
7. Reconnect the power cords and any cables that you removed.
8. Turn on the peripheral devices and the compute node.

Removing the front handle

Use this information to remove the front handle.
Before you remove the front handle, complete the following steps:
1. Read "Safety" on page vii and "Installation guidelines" on page 93.
2. If the compute node is installed in an IBM NeXtScale n1200 Enclosure, remove
it (see "Removing a compute node from a chassis" on page 96 for instructions).
3. Carefully lay the compute node on a flat, static-protective surface with the
cover side down, orienting the compute node with the bezel pointing toward
you.
To remove the front handle, complete the following steps.
Filler
Chapter 5. Removing and replacing components
119