IBM NeXtScale nx360 M4 Installation And Service Manual page 144

Before you remove the operator information panel, read "Safety" on page vii and
"Installation guidelines" on page 93.
To remove the operator information panel, complete the following steps.
1. Use a T8 torx (part number 00FK488, provided on the back of the chassis)
Figure 43. Screw removal
2. Pull out the connector from the system board.
Figure 44. Connector pull out
3. Carefully pull the operator information panel outward a little to make a space
Figure 45. Pull the operator information panel
4. Lift the operator information panel from the compute node.
126
IBM NeXtScale nx360 M4 Type 5455: Installation and Service Guide
screwdriver to remove the screw from the operator information panel. Place it
in a safe place.
Screw
for removal.
T8 torx screwdriver
Back of chassis