IBM NeXtScale nx360 M4 Installation And Service Manual page 265

6. (Trained service technician only) Remove the
affected microprocessor and check the
microprocessor socket pins for any damaged pins. If
a damage is found, replace the system board.
7. (Trained service technician only) If the problem is
related to microprocessor socket pins, replace the
system board.
806f0313-1701ffff A software NMI has occurred on
system [ComputerSystemElementName].
(NMI State)
Explanation: This message is for the use case when an
implementation has detected a Software NMI.
Severity: Error
Alert Category: Critical - Other
Serviceable: Yes
CIM Information: Prefix: PLAT and ID: 0228
SNMP Trap ID: 50
Automatically notify Support: No
User response:
1. Check the device driver.
2. Reinstall the device driver.
3. Update all device drivers to the latest level.
4. Update the firmware (UEFI and IMM).
806f0323-2101ffff Power cycle of system
[ComputerSystemElementName]
initiated by watchdog
[WatchdogElementName]. (IPMI
Watchdog)
Explanation: This message is for the use case when an
implementation has detected a Power Cycle by
Watchdog occurred.
Severity: Info
Alert Category: System - Other
Serviceable: No
CIM Information: Prefix: PLAT and ID: 0374
SNMP Trap ID:
Automatically notify Support: No
User response: No action; information only.
806f040c-2001ffff [PhysicalMemoryElementName]
Disabled on Subsystem
[MemoryElementName]. (DIMM 1)
Explanation: This message is for the use case when an
implementation has detected that Memory has been
Disabled.
Severity: Info
806f0313-1701ffff • 806f040c-2003ffff
Alert Category: System - Other
Serviceable: No
CIM Information: Prefix: PLAT and ID: 0131
SNMP Trap ID:
Automatically notify Support: No
User response:
1. Make sure the DIMM is installed correctly.
2.
If the DIMM was disabled because of a memory
fault (memory uncorrectable error or memory
logging limit reached), follow the suggested actions
for that error event and restart the server.
3. Check the IBM support website for an applicable
retain tip or firmware update that applies to this
memory event. If no memory fault is recorded in
the logs and no DIMM connector error LED is lit,
you can re-enable the DIMM through the Setup
utility or the Advanced Settings Utility (ASU).
806f040c-2002ffff
Explanation: This message is for the use case when an
implementation has detected that Memory has been
Disabled.
Severity: Info
Alert Category: System - Other
Serviceable: No
CIM Information: Prefix: PLAT and ID: 0131
SNMP Trap ID:
Automatically notify Support: No
User response:
1. Make sure the DIMM is installed correctly.
2. If the DIMM was disabled because of a memory
fault (memory uncorrectable error or memory
logging limit reached), follow the suggested actions
for that error event and restart the server.
3. Check the IBM support website for an applicable
retain tip or firmware update that applies to this
memory event. If no memory fault is recorded in
the logs and no DIMM connector error LED is lit,
you can re-enable the DIMM through the Setup
utility or the Advanced Settings Utility (ASU).
806f040c-2003ffff
Explanation: This message is for the use case when an
implementation has detected that Memory has been
Disabled.
Severity: Info
Appendix A. Integrated Management Module II (IMM2) error messages
[PhysicalMemoryElementName]
Disabled on Subsystem
[MemoryElementName]. (DIMM 2)
[PhysicalMemoryElementName]
Disabled on Subsystem
[MemoryElementName]. (DIMM 3)
247