IBM NeXtScale nx360 M4 Installation And Service Manual page 243

6. Replace the PCI adapter and make sure the PCI
adapter is functioning normally.
80070614-2201ffff Sensor [SensorElementName] has
transitioned to non-recoverable. (TPM
Phy Pres Set)
Explanation: This message is for the use case when an
implementation has detected a Sensor transitioned to
non-recoverable.
Severity: Error
Alert Category: Critical - Other
Serviceable: Yes
CIM Information: Prefix: PLAT and ID: 0530
SNMP Trap ID: 50
Automatically notify Support: No
User response:
1. Update the server firmware (see Recovering the
server firmware).
2. If the problem persists, (trained technician only)
replace the system board (see Removing the system
board and Installing the system board).
8008010f-2101ffff Device
[LogicalDeviceElementName] has been
added. (Phy Presence Jmp)
Explanation: This message is for the use case when an
implementation has detected a Device was inserted.
Severity: Info
Alert Category: System - Other
Serviceable: No
CIM Information: Prefix: PLAT and ID: 0536
SNMP Trap ID:
Automatically notify Support: No
User response: No action; information only.
80080128-2101ffff Device
[LogicalDeviceElementName] has been
added. (Low Security Jmp)
Explanation: This message is for the use case when an
implementation has detected a Device was inserted.
Severity: Info
Alert Category: System - Other
Serviceable: No
CIM Information: Prefix: PLAT and ID: 0536
SNMP Trap ID:
Automatically notify Support: No
80070614-2201ffff • 800b050c-2581ffff
User response: No action; information only.
800b010c-2581ffff
Explanation: This message is for the use case when
Redundancy Lost has asserted.
Severity: Error
Alert Category: Critical - Memory
Serviceable: Yes
CIM Information: Prefix: PLAT and ID: 0802
SNMP Trap ID: 41
Automatically notify Support: No
User response:
1. Check the system-event log for DIMM failure
events (uncorrectable or PFA) and correct the
failures.
2. Re-enable mirroring in the Setup utility.
800b030c-2581ffff
Explanation: This message is for the use case when a
Redundancy Set has transitioned from Redundancy
Degraded or Fully Redundant to Non-
redundant:Sufficient.
Severity: Warning
Alert Category: Warning - Memory
Serviceable: Yes
CIM Information: Prefix: PLAT and ID: 0806
SNMP Trap ID: 43
Automatically notify Support: No
User response:
1. Check the system-event log for DIMM failure
events (uncorrectable or PFA) and correct the
failures.
2. Re-enable mirroring in the Setup utility.
800b050c-2581ffff
Explanation: This message is for the use case when a
Redundancy Set has transitioned to
Non-redundant:Insufficient Resources.
Severity: Error
Appendix A. Integrated Management Module II (IMM2) error messages
Redundancy Lost for
[RedundancySetElementName] has
asserted. (Backup Memory)
Non-redundant:Sufficient
Resources from Redundancy Degraded
or Fully Redundant for
[RedundancySetElementName] has
asserted. (Backup Memory)
Non-redundant:Insufficient
Resources for
[RedundancySetElementName] has
asserted. (Backup Memory)
225