IBM NeXtScale nx360 M4 Installation And Service Manual page 162

3. Carefully lay the compute node on a flat, static-protective surface, orienting the
To install the hard disk drive backplate, complete the following steps.
Figure 63. Installing backplate for 2.5-inch
Figure 64. Installing backplate for 1.8-inch
1. Remove the cover (see "Removing the compute node cover" on page 110).
2. Align the backplate with the hard disk drive cage and the connector on the
3. Close the release latch.
4. Slide the hard disk drive into the bay until it is firmly seated in the connector.
5. Lock the hard disk drive into place by closing the release lever.
After you install the hard disk drive backplate, complete the following steps:
144
IBM NeXtScale nx360 M4 Type 5455: Installation and Service Guide
compute node with the bezel pointing toward you.
2.5-inch Hard disk
drive backplate
1.8-inch solid state
drive backplate
system board and press the backplate into position until it is fully seated in the
connector.