IBM NeXtScale nx360 M4 Installation And Service Manual page 349

406-800-000 IANet:Registers Test Aborted
Explanation: Registers test was canceled.
Severity: Warning
Serviceable: No
Recoverable: No
Automatically notify Support: No
406-801-000 IANet:EEPROM Test Aborted
Explanation: EEPROM test was canceled.
Severity: Warning
Serviceable: No
Recoverable: No
Automatically notify Support: No
406-802-000 IANet:FIFO Test Aborted
Explanation: FIFO test was canceled.
Severity: Warning
Serviceable: No
Recoverable: No
Automatically notify Support: No
406-803-000 IANet:Interrupts Test Aborted
Explanation: Interrupt test was canceled.
Severity: Warning
Serviceable: No
Recoverable: No
Automatically notify Support: No
406-804-000 IANet:Loopback Test Aborted
Explanation: Loopback test was canceled.
Severity: Warning
Serviceable: No
Recoverable: No
Automatically notify Support: No
406-900-000 IANet:Registers Test Failed
Explanation: A failure was detected during the
Registers test.
Severity: Error
Serviceable: Yes
Recoverable: No
Automatically notify Support: No
406-800-000 • 406-903-000
User response: Complete the following steps:
1. Check component firmware level and upgrade if
necessary. The installed firmware level can be found
in the DSA Diagnostic Event Log within the
Firmware/VPD section for this component.
2. Rerun the test.
3. If failure remains, refer to "Troubleshooting by
symptom" in the system "Installation and Service
Guide" for the next corrective action.
406-901-000 IANet:EEPROM Test Failed
Explanation: A failure was detected during the
EEPROM test.
Severity: Error
Serviceable: Yes
Recoverable: No
Automatically notify Support: No
User response: Complete the following steps:
1. Check component firmware level and upgrade if
necessary. The installed firmware level can be found
in the DSA Diagnostic Event Log within the
Firmware/VPD section for this component.
2. Rerun the test.
3. If failure remains, refer to "Troubleshooting by
symptom" in the system "Installation and Service
Guide" for the next corrective action.
406-902-000 IANet:FIFO Test Failed
Explanation: A failure was detected during the FIFO
test.
Severity: Error
Serviceable: Yes
Recoverable: No
Automatically notify Support: No
User response: Complete the following steps:
1. Check component firmware level and upgrade if
necessary. The installed firmware level can be found
in the DSA Diagnostic Event Log within the
Firmware/VPD section for this component.
2. Rerun the test.
3. If failure remains, refer to "Troubleshooting by
symptom" in the system "Installation and Service
Guide" for the next corrective action.
406-903-000 IANet:Interrupts Test Failed
Explanation: A failure was detected during the
Interrupt test.
Severity: Error
Serviceable: Yes
Appendix C. DSA diagnostic test results
331