IBM NeXtScale nx360 M4 Installation And Service Manual page 170

Figure 74. 1.8-inch hard disk drive removal
7. Pull the plunger of the 1.8-inch hard disk drive cage outward and rotate the
Figure 75. Put the 1.8-inch hard disk drive cage downward
If you are instructed to return the component or optional device, follow all
packaging instructions, and use any packaging materials for shipping that are
supplied to you.
Installing a 1.8-inch hard disk drive
Use this information to install a 1.8-inch hard disk drive.
The following notes describe the types of hard disk drives that the server supports
and other information that you must consider when you install a hard disk drive:
v Depending on the model, the compute node supports up to four 1.8-inch
v For a list of supported optional devices for the server, see http://
v Inspect the drive and drive bay for signs of damage.
v Make sure that the drive is correctly installed in the drive bay.
v See the documentation for the ServeRAID adapter for instructions for installing
v All drives in the server must have the same throughput speed rating; using
v You must turn off the compute node when you perform any steps that involve
152
IBM NeXtScale nx360 M4 Type 5455: Installation and Service Guide
Handle
cage downward until the cage snaps into place.
2
SAS/SATA hard disk drives in the bays.
www.ibm.com/systems/info/x86servers/serverproven/compat/us.
a hard disk drive.
drives with different speed ratings might cause all drives to operate at the speed
of the slowest drive.
installing or removing cables.
1