Procedure
1. Go to the front of the system chassis.
2. Place your fingers on the indentations (B) located on both sides of the cover, as shown in Figure 7 on
page 9.
Figure 7. Removing the front cover
3. Pull the cover (A) away from the system, as shown in Figure 7 on page 9.
Removing the system fans
Learn how to remove the system fans.
Before you begin
Use tape, a marker, or a pencil to mark the location of each component that you remove. The marks are
helpful as a reference when you replace each component.
About this task
To remove the system fans, complete the following steps:
Procedure
1. Put your thumb against the latch (A), and put your index finger against the latch (B), as shown in Figure
8 on page 10.
Installing the IBM Power System E950 (9040-MR9) 9