Select this choice to view information about the UEFI 1.10 and UEFI 2.0
compliant adapters and drivers installed in the server.
– Processors
Select this choice to view or change the processor settings.
– Memory
Select this choice to view or change the memory settings.
– Devices and I/O Ports
Select this choice to view or change assignments for devices and
input/output (I/O) ports. You can configure the serial ports, configure remote
console redirection, enable or disable integrated Ethernet controllers, the
SAS/SATA controllers, SATA optical drive channels, PCI slots, and video
controller. If you disable a device, it cannot be configured, and the operating
system will not be able to detect it (this is equivalent to disconnecting the
device).
– Power
Select this choice to view or change power capping to control consumption,
processors, and performance states.
– Operating Modes
Select this choice to view or change the operating profile (performance and
power utilization).
– Legacy Support
Select this choice to view or set legacy support.
- Force Legacy Video on Boot
Select this choice to force INT video support, if the operating system does
not support UEFI video output standards.
- Rehook INT 19h
Select this choice to enable or disable devices from taking control of the
boot process. The default is Disable.
- Legacy Thunk Support
Select this choice to enable or disable UEFI to interact with PCI mass
storage devices that are non-UEFI compliant. The default is Enable.
- Infinite Boot Retry
Select this choice to enable or disable UEFI to infinitely retry the legacy
boot order. The default is Disable.
- BBS Boot
Select this choice to enable or disable legacy boot in BBS manner. The
default is Enable.
– System Security
Select this choice to view or configure Trusted Platform Module (TPM)
support.
– Integrated Management Module
Select this choice to view or change the settings for the integrated
management module.
- Power Restore Policy
Select this choice to set the mode of operation after the power lost.
- Commands on USB Interface
Select this choice to enable or disable the Ethernet over USB interface on
IMM. The default is Enable.
Chapter 2. Configuration information and instructions
27