IBM NeXtScale nx360 M4 Installation And Service Manual page 244

806f0007-0301ffff • 806f000f-220101ff
Alert Category: Critical - Memory
Serviceable: Yes
CIM Information: Prefix: PLAT and ID: 0810
SNMP Trap ID: 41
Automatically notify Support: No
User response:
1. Check the system-event log for DIMM failure
events (uncorrectable or PFA) and correct the
failures.
2. Re-enable mirroring in the Setup utility.
806f0007-0301ffff [ProcessorElementName] has
Failed with IERR. (CPU 1)
Explanation: This message is for the use case when an
implementation has detected a Processor Failed - IERR
Condition.
Severity: Error
Alert Category: Critical - CPU
Serviceable: Yes
CIM Information: Prefix: PLAT and ID: 0042
SNMP Trap ID: 40
Automatically notify Support: No
User response:
1.
Make sure that the latest level of firmware and
device drivers are installed for all adapters and
standard devices, such as Ethernet, SCSI, and SAS.
Important: Some cluster solutions require specific
code levels or coordinated code updates. If the
device is part of a cluster solution, verify that the
latest level of code is supported for the cluster
solution before you update the code.
2. Update the firmware (UEFI and IMM) to the latest
level (Updating the firmware).
3. Run the DSA program.
4. Reseat the adapter.
5. Replace the adapter.
6. (Trained technician only) Replace microprocessor n.
7.
(Trained technician only) Replace the system board.
(n = microprocessor number)
806f0007-0302ffff [ProcessorElementName] has
Failed with IERR. (CPU 2)
Explanation: This message is for the use case when an
implementation has detected a Processor Failed - IERR
Condition.
Severity: Error
Alert Category: Critical - CPU
Serviceable: Yes
226
IBM NeXtScale nx360 M4 Type 5455: Installation and Service Guide
CIM Information: Prefix: PLAT and ID: 0042
SNMP Trap ID: 40
Automatically notify Support: No
User response:
1. Make sure that the latest level of firmware and
device drivers are installed for all adapters and
standard devices, such as Ethernet, SCSI, and SAS.
Important: Some cluster solutions require specific
code levels or coordinated code updates. If the
device is part of a cluster solution, verify that the
latest level of code is supported for the cluster
solution before you update the code.
2.
Update the firmware (UEFI and IMM) to the latest
level (Updating the firmware).
3.
Run the DSA program.
4. Reseat the adapter.
5. Replace the adapter.
6. (Trained technician only) Replace microprocessor n.
7. (Trained technician only) Replace the system board.
(n = microprocessor number)
806f0009-1301ffff [PowerSupplyElementName] has
been turned off. (Host Power)
Explanation: This message is for the use case when an
implementation has detected a Power Unit that has
been Disabled.
Severity: Info
Alert Category: System - Power Off
Serviceable: No
CIM Information: Prefix: PLAT and ID: 0106
SNMP Trap ID: 23
Automatically notify Support: No
User response: No action; information only.
806f000f-220101ff The System
[ComputerSystemElementName] has
detected no memory in the system.
(ABR Status)
Explanation: This message is for the use case when an
implementation has detected that memory was detected
in the system.
Severity: Error
Alert Category: Critical - Memory
Serviceable: Yes
CIM Information: Prefix: PLAT and ID: 0794
SNMP Trap ID: 41
Automatically notify Support: No
User response: This is a UEFI detected event. The