Removing And Replacing Structural Parts; Removing The Compute Node Cover - IBM NeXtScale nx360 M4 Installation And Service Manual

Figure 22. GPU tray installation
4. Hold the front of the compute node and slide the GPU tray forward to the
5. Reinstall the PCI riser-cage assembly in the GPU tray (see "Replacing a PCI
6. Replace the cover (see "Installing the compute node cover" on page 111).

Removing and replacing structural parts

Use this information to remove and replace consumable and structural parts.
Replacement of structural parts is your responsibility. If IBM installs a structural
part at your request, you will be charged for the installation.
The illustrations in this document might differ slightly from your hardware.

Removing the compute node cover

Use this information to remove the cover from a compute node.
Before you remove the compute node cover, complete the following steps:
1. Read "Safety" on page vii and "Installation guidelines" on page 93.
2. If the compute node is installed in an IBM NeXtScale n1200 Enclosure, remove
3. Carefully lay the compute node on a flat, static-protective surface, orienting the
Statement 12
110
IBM NeXtScale nx360 M4 Type 5455: Installation and Service Guide
closed position, until it clicks into place.
riser-cage assembly in the GPU tray" on page 157).
it (see "Removing a compute node from a chassis" on page 96 for instructions).
compute node with the bezel pointing toward you.