Returning A Device Or Component; Removing And Replacing Server Components; Removing And Replacing Consumable And Structural Parts; Removing The Cover - IBM System x3550 M5 Type 5463 Installation And Service Manual

Returning a device or component

If you are instructed to return a device or component, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.

Removing and replacing server components

This section provides information for removing and replacing components in the
server.

Removing and replacing consumable and structural parts

Replacement of consumable and structural parts is your responsibility. If IBM
installs a consumable and structural part at your request, you will be charged for
the installation.
The illustrations in this document might differ slightly from your hardware.

Removing the cover

Use this information to remove the cover.
About this task
To remove the server cover, complete the following steps:
Procedure
1. Read the safety information that begins on "Safety" on page vii and
2. Turn off the server and peripheral devices and disconnect the power cords and
3. If the server has been installed in a rack, slide the server out from the rack
4. Remember to check if the cover is locked. If it is locked, unlock the cover first.
Unlock
Figure 33. Unlocking cover
126
IBM System x3550 M5 Type 5463: Installation and Service Guide
"Installation guidelines" on page 122.
all external cables, if necessary.
enclosure.
Lock
Latch