Interface Specifications For Qsfp+ Dac Breakout Cables For An Acx5000 - Juniper ACX5048 Manual

ACX5048 and ACX5096 Universal Access Router
Table 38: SFP+ Active Direct Attach Copper Cable Specifications (continued)
Product Number
QFX-SFP-DAC-10MA
Related
Documentation
Interface Specifications for QSFP+ DAC Breakout Cables for an ACX5000 Router
82
Specifications
Rate
Connector type
Supply voltage
Power consumption (per end)
Storage temperature
Cable type
Wire AWG
Minimum cable bend radius
Cable characteristic impedance
Crosstalk between pairs
Length
Interface Specifications for SFP, SFP+, and QSFP+ Transceivers for an ACX5000
Router on page 62
Interface Specifications for QSFP+ DAC Breakout Cables for an ACX5000 Router on
page 82
Interface Specifications for QSFP+ DAC Cables for an ACX5000 Router on page 86
Quad small form-factor pluggable plus (QSFP+) transceiver to four SFP+ direct-attach
copper (DAC) breakout cables are suitable for in-rack connections between servers and
the ACX5000 routers.
Table 39 on page 83 describes the Junos OS software releases that support third-party
DAC breakout cables. Earlier releases do not support third-party breakout cables.
You can use breakout cables purchased from a third party. These cables should meet
the specifications described in
CAUTION: If you are having a problem running a Juniper Networks device
that is using a third-party optic or cable, the Juniper Networks Technical
Assistance Center (JTAC) can help you diagnose the source of the problem.
10-Gbps full-duplex serial transmission
None. SFPs are permanently attached.
3.3 V
0.627 W
°
–40 C to 85
Twinax
28 AWG
2 in. (5 cm)
100 ohms
2% maximum
10 m (32.8 ft)
Table 40 on page 83.
Copyright © 2015, Juniper Networks, Inc.
°
C