AGFA DRYSTAR AXYS Service Manual page 65

DD+DIS033.07E
Accessible via ...
Accessible via menu:
Purpose:
Default value:
Example browser
screen:
Key-Operator - Change Image quality settings
Daily used name
Modality AE-title
Look Up Table:
Interpolation:
Maximum density:
Accept changes Discard changes Reset Values
NOTE:
Interpolation setting "Linear" usually gives too smooth image impression.
Interpolation settings "Replication" usually gives too "pixely" image impression.
Both settings are used in exceptional cases only.
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 1
06-2008
Controls, Connections, and Setup Procedures
Local keypad and browser
Key-operator menu - 2 Change settings - 4 Image Quality -
<Modality XYZ>
Adjust Image Quality in case it cannot be adapted at the
modality.
•
Look-up table: Kanamori. Refer to
•
Interpolation: Cubic HiRes -0.7. Refer to Figure 19.
•
Dmax 3.20.
Welcome to this
DryStar Axys printer
CT2
CT2_ARC
Linear
Kanamori
Kanamorilike
Replication
Linear
CubicHi-res
CubicBell
280
285
290
295
DOCUMENT CONTROL NOTE:
DRYSTAR AXYS
Type 5367/100
Key-Operator - Change Image quality settings
Select kanamori like value:
Select abosulte smoothing factor: (advised = -0.7)
Accept changes Discard changes Reset Values
Figure 19
Figure 18.
X
Welcome to this
DryStar Axys printer
100
-0.7
536701fs.cdr
Chapter 1 / 29
Agfa Company Confidential