Resistor Check - AGFA DRYSTAR AXYS Service Manual

DD+DIS033.07E
3.3

Resistor Check

•
TO BE
Whenever film stripes in the film run direction seem to be caused by a defective
DONE
Thermal Print Head.
REQUIRED TOOLS:
•
Magnifying glass 8x (CM+9.9579.9904.0)
REQUIRED TIME:
•
15 minutes
PURPOSE:
With the resistor check it is possible to check if line artifacts are caused by an
electrical problem or by dirt on the thermal head. If the resistor check fails it's not
necessary to perform a dry cleaning: The Print Head can be replaced right away.
The resistor check is performed in 2 (or more) steps:
1) A rough resistor measurement of all the resistor values. If large resistor drifts
show up, a message will show up to replace the Print Head.
2) A fine resistor measurement in one of 44 predefined areas of the image (see
Figure 22): The Service Engineer can enter this area at the printer, where he
suspects a defective resistor due to a line in print direction. If certain resistor
values in this specified region are out of range, a message will show up to
replace the Print Head.
3) This fine resistor measurement can be repeated for each suspected area.
How? (1) Go to the
•
•
(2) Follow the instructions on the screen.
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 1
06-2008
browser service menu "7 Service Actions - 6 Resistor Check" or
local keypad key-operator menu 7 Service Actions - 5 Resistor Check.
DOCUMENT CONTROL NOTE:
DRYSTAR AXYS
Type 5367/100
Repair and Service
Adjustments and Calibrations
Agfa Company Confidential
Chapter 3.6 / 36