AGFA DRYSTAR AXYS Service Manual page 389

DD+DIS032.07E
2.2.4 How to evaluate the Infocounter
What to check in the
infocounter
1.1 Serial number and
Installation date
1.4 Software Info
What to check in the
infocounter
2.3 Reliability
3.3 Hardware
Modification History
3.4 Software Modification
History
5.3 Retries
5.7 Error History
5.8 Error list (sorted by
relative) and
5.9 Error list (sorted by
total):
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 0
09-2007
Infocounters.txt evaluation
Comment
Compare device serial number with chapter 8
'Manufacturing Standard Modification' to determine whether
the device possibly requires a modification.
Refer to 3.3 (infocounter.txt), 'HW Modification History', to
check already made modifications.
Compare the currently installed SW version with the latest
SW version described in chapter 3.8, SW releases,
patches. In case a recommended SW patch is available,
install this SW patch.
Refer to section 4.3.
Infocounters.txt evaluation
Comment
Should normally be not higher than 0.05. Higher fault rates
need a thorough investigation.
By comparing the status of the device with the available
modifications (refer to Technical Documentation chapter 8)
the exact hardware status can be determined.
By checking the software modification history it can be
determined, whether a recent software upgrade solved a
problem, that occurred quite often in the error list in the
past
Many retries (> 1%, based on relative prints) have to be
investigated: They may reduce the throughput of the
device.
Check which errors occurred in the last days, how often
they appeared as well as the CBF (cycles between failures)
of these errors. This gives an overview of the current status
of the machine.
Troubleshoot these errors with the help of the technical
documentation, chapter 3.3, 'Troubleshooting'.
DOCUMENT CONTROL NOTE:
DRYSTAR AXYS
Type 5367
Maintenance
Chapter 9 / 11
Agfa Company Confidential