AGFA DRYSTAR AXYS Service Manual page 448

DD+DIS033.07E
Term
F
FIFO
Film batch
Film Sensitometry
Film type
FireWire
Flash EPROM
Fog level
FPGA
FSE
FTP
Term
G
GSN
Term
H
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 0
10-2007
Short description
First In, First Out.
Way of storing data that first selects the data that have been
entered first.
Used in (print) queues.
Number printed on the film packet.
It changes with every new film emulsion. Only the films with
the same film batch have exactly the same characteristics.
Calibration of the film.
By calibrating, the printer gets a table with certain density
values for certain control values.
Film of a certain producer or a similar producer but with
different characteristics (sensitivity, contrast).
Serial bus standard also known as IEEE1394. Data rate up
to 400 Mb/s.
An EPROM in which data have to be deleted in fixed blocks
instead of separate bytes.
Lowest optical density that can be measured on the film.
Field Programmable Gate Array.
A logic chip, which can be programmed. An FPGA can be
programmed after its production.
Field Service Engineer. Service technician.
File Transfer Protocol.
A network protocol required for file transfer within the
network.
Short description
Global Support Network. Part of the Agfa HealthCare service
organisation.
Short description
DOCUMENT CONTROL NOTE:
DRYSTAR AXYS
Type 5367/100
Glossary
Chapter 12 / 6
Agfa Company Confidential