Toyota Celica 2000 Repair Manual page 737

SR-50
p
N
-
POWER STEERING GEAR
STEERING
As shown in the illustration, bend the wire to the circular
(d)
direction to prevent damage to the boot.
Employ the same manner described above to the other
(e )
side.
F09925
13. INSTALL RH AND LH TIE ROD ENDS AND LOCK NUTS
Screw the lock nut and tie rod end onto the rack end until
{a)
the match marks are aligned.
After adjusting toe-in, torque the nut
(b)
(See page SA-4).
Torque:
74
Employ the same manner described above to tho other
(c)
side.
14. INSTALL 2 TURN PRESSURE TUBES
Using SST, install the 2 turn pressure tubes.
SST 09633-00020
Torque: 20 N·m (200 kgf.cm, 1 4 ft·lbf)
HINT:
Use a torque wrench with a fulcrum length of 300 mm
( 1 1 .8 1 in.).
This torque value is effective in case that SST is parallel
F0990!
to a torque wrench.
54
N·m (750 kgl-cm, ft·lbf)