T
BODY
BACK DOOR
DISASSEMBLY
1 .
w/ Rear spoiler:
REMOVE REAR SPOILER
2.
REMOVE DOOR PULL HANDLE
3.
REMOVE BACK DOOR TRIM BOARD
Using a screwdriver, remove the back door trim board.
HINT:
Tape the screwdriver tip before use.
4.
REMOVE REAR WIPER ARM
HINT:
•
At the time of reassembly, please refer to the following
items
Operate the wiper motor once and turn the wiper switch
OFF.
Install the rear wiper arm and tighten the nut by hand.
•
Adjust the installation position fo the wiper arm at a point
in defogger pattern.
•
lighten the nut.
Torque: 5.4 N.m (55 kgf.cm, 48 in.·lbf)
5.
REMOVE REAR WIPER MOTOR
(a)
Disconnect the connector.
Unfasten the 3 bolts and remove the rear wiper motor.
(b)
Torque: 5.4 N-m (55 kgf.crn,
(c)
Remove the packing.
80-23
48
in.-lbf)