Heater Control Assembly Removal - Toyota Celica 2000 Repair Manual

AIR CONDITIONING
HEATER CONTROL
REMOVAL
REMOVE CENTER CLUSTER FINISH PANEL
1 .
(See page B0-79)
2.
DISCONNECT HEATER CONTROL CABLES
NOTICE:
When the air mix damper control cables is disconnected,
should not bend the cable.
3. REMOVE HEATER CONTROL ASSEMBLY
Release the 2 claws and pull out the A/C control assembly, then
disconnect the connector .
4. REMOVE HEATER CONTROL PANEL
(a) Remove the 2 screws.
Slide and remove the NC control assembly.
(b)
ASSEMBLY
AC-67