Back Door Glass Removal; Remove Center Stop Light; Remove Back Door Glass - Toyota Celica 2000 Repair Manual

Cli
/·.: 10
T
T
/j­
/1 � �
_ _ , (
\ )", 1
'' "
·
\
�� . L \ _
\"- --�- -
Protective Tape
.. r::: � 1
j�
Adhesive Area
A
1es1ve
BODY
REMOVAL
1 .
2 .
3.
4.
Using a screwdriver, remove the back door trim board.
HINT:
Tape the screwdriver tip before use.
Hl? % 0
5.
(a)
(b)
the center stop tight in order A, B as shown in the illustra-
tion ..
6. REMOVE BACK WINDOW OPENING TRIM
7.

REMOVE BACK DOOR GLASS

Insert a piano wire between body and glass and let it pass
(a)
through.
Tle both wire ends to wooden blocks or similar object
(b)
HINT:
Apply protective tape to the outer surface to keep the surface
- --- __ - -
--
from being scratched.
NOTICE:
When separating the glass, take care not to damage the
paint and exterior.
Cut the adhesive by pulling the piano wire around it.
{c)
HINT:
Cut the adhesive areas as shown in the illustration.
mn%
rea
--
BACK DOO R GLASS
w/ Rear spoiler:
REMOVE REAR SPOILER
REMOVE REAR WIPER ARM
REMOVE DOOR PULL HANDLE
REMOVE BACK DOOR TRIM BOARD

REMOVE CENTER STOP LIGHT

Remove the 2 nuts.
Disconnect the connector and washer hose, then remove
80-j;S