SUPPLEMENTAL RESTRAINT SYSTEM
H1100il
H11S&l
LH:
RH:
�
FHONT AIRBAQ SE:NSOR
INSTALLATION
1 .
INSTALL FRONT AIRBAG SENSOR LH AND RH
Install the front airbag sensors with the 4 bolts.
(a)
Torque: 20 N-m (205 kgf-cm, 1 5 ft-lbf)
(b )
Connect the front airbag sensor connector.
NOTICE:
•
Connection of the connector is done after the sensor
assembly has been installed.
Make sure the sensor is installed with the specified
torque.
•
If the sensor has been dropped, or there are cracks,
dents or other defects in the case, brackets or con�
nectar, replace the removed sensor with a new one.
•
The front sensor is equipped with an electrical con�
necllon check mechanism. Be sure to lock this mech�
anism securely when connecting the connector. If the
connector is not securely locked, a malfunction code
will be detected by the diagnostic system.
IH2013
HINT:
lnstaH the front airbag sensor with the arrow on the sensor fac
ing toward the front of the vehicle.
2.
INSTALL HEAD LIGHT
Instal! head lights with the 4 bolts and 2 screws (See page
BE-20).
3.
INSTALL AIR CLEANER CASE
Instal! the air cleaner case with the 2 bolts.
4.
INSTALL AIR FILTER
5.
INSTALL AIR CLEANER CAP
6.
INSTALL AIR CLEANER HOSE
7.
INSTALL UPPER FRONT FENDER APRON SEAL
Install the upper front fender apron seal with the 5 clips.
RS-61