Toyota Celica 2000 Repair Manual page 491

AX-28
AUTOMATIC TAANSAXLE (U24QE)
-
• ; ·-
• !
-
,,_,
--
-
-
,// -
-�----®
Wi t h t h e br a ke
shi f t whi l e hol d i n g
l e ase but t o n
pedal
( T he i g ni t i o n swi t c h must be
ON posi t i o n. )
in.
Shi f t whi l e hol d i n g t h e l o ck
r e l e ase but t o n i n .
Shi f t nor m al l y
N
.
.
Connect the 2 key interlock cable clamps.
(e)
(f) Pull in the cable while pressing tho clip of the key interlock
cable.
3. INSTALL AIR CONDITIONING UNIT (See page
AC-29)
INSTALL INSTRUMENT PANEL (See page B<Hl5)
4.
INSPECT KEY INTERLOCK AND SHIFT LOCK OP·
5.
ERATION
Check that a key can be turn from ACC to LOCK only
(a )
when the shift lever is in P position.
Check that the key cannot be turned to LOCK when the
(b)
shift lever is position in other than P position.
(c) When the ignition key is in LOCK, check that pressing the
shift release button enables the shift lever to shift from P
position to other positions.
When shifting it to each position, make sure that the shift­
(d)
ing fever moves smoothly, can be moderately operated
and the position indicator displays correctly.
Positions which can be operated without pressing
the shift lever knob button
R � N
Positions which can be operated only while pressing
depr e ssed,
the shift lever knob button
r e ­
0 0 2 � L, N � R -7 P
Positions which can be operated only while pressing
the lock
the shift lever knob button, ignition switch ON and
in
brake pedal depressed
P -. R
When starting the engine make sure that the vehicle
(e)
moves forward when shifting form N to D position, and
moves rearward when shifting to R position.
6. ADJUSTMENT IN CASE OF MALFUNCTION
When the key can not be turned from ACC to LOCK even
(a)
though the shift lever is in P position:
D05895
This is the condition where the cable end on the ignition
key side is not returned to the position where it can be
locked. The condition is caused by undue bending of the
cable, rotative resistance of the pin on the shift lever side,
or increased resistance due to any reason such as twist­
ing of the cable. Reinstall and readjust the key interlock
cable.
FLOOR SHIFT ASSEMBLY
-7 -7 -7
· - )
D M D, l 2 -; 0
--7
N