Roof Side Moulding Installation; Clean Contract Surface Of Body - Toyota Celica 2000 Repair Manual

B0-44
M
Primer
Pr i m erM
-
B DV
INSTALLATION
1.

CLEAN CONTRACT SURFACE OF BODY

Using a heat light, heat the moulding surface to 40 - 60
(a) ·c
NOTICE:
Do not heat the body excessively.
Using a knife, cut away any rough areas on the body.
(b)
NOTICE:
Be careful not to damage the body.
Wipe off stains with cleaner.
(c)
If reusing the moulding:
2.
CLEAN MOULDING
Using a heat light, heat the moulding surface to 20 - 30
(a) ·c
NOTICE:
Do not heat the moulding excessively.
(b) Using a knife, cut the remaining adhesive from the mould-
ing.
NOTICE:
Be careful not to damage the moulding.
Wipe off stains with cleaner.
(c)
3. COAT CONTRACT SURFACE OF BODY WITH PRIMER
" M "
Using a brush, coat the contact surface on the body with Primer
M as shown in the illustration.
-�
Front and rear end:
A: 66 mm (2.60 ln.)
A
NOTICE:
•
Let the primer coating dry for 3 minutes or more.
•
Do not coat the adhesive.
•
Do not keep any of the opened Primer M for later use.
ROOF SIDE MOULDING
(104 - 140 " F).
(68 - 86 "F).