Toyota Celica 2000 Repair Manual page 792

SUPPLEMENTAL RESTRAINT SYSTEM
(f)
or Mor e }
Tires
{5
CAUTION:
Make sure that the wire harness are tight. It is very danger­
ous when loose wire harness results i n the tires coming
free due to the shock from the alrbag deploying.
HINT:
Place the SST connector and wire harness inside tires. Secure
at least 1 m (3 ft) of slack lor the wire harness.
fl054()J
(g)
NOTICE:
To avoid damaging the SST connector and wire harness,
do not lock the secondary lock of the twin lock. Also, se�
cure some slack for the SST wire harness inside the tire.
(h)
HINT:
The airbag deploys simultaneously as the LED of the SST ac­
tivation switch lights up.
(i)
CAUTION:
•
•
•
HOOSH
S I DE AIR BAG ASSEMBLY
Place the tires.
Place at least 2 tires under the tire to which the side
(i )
airbag assembly is tied.
(2) Place at least 2 tires over the tire to which the side
airbag assembly is tied. The top tire should have the
wheel installed.
(3) Tie the tires together with 2 wire harness.
Install the SST
Connect the connectors of the 2 SST to the side airbag
assembly connector.
SST 09082-()0700, 09082-00750
Deploy the airbag.
( 1 ) Connect the SST red clip to the battery positive (+)
( ) terminal.
terminal and the black clip to the battery negative
�
Check that no one is within 1 o m (33 ft) area around
(2)
the tire which the side airbag assembly is tied to.
Press the SST activation swltch and deploy the air·
(3)
bag.
Dispose of the side airbag assembly.
The side airbag assembly is very hot when the airbag
is deployed, so leave it alone for at least 30 minutes
after deployment.
Use gloves and safety glasses when handling a side
airbag assembly with the deployed airbag.
Do not apply water etc. to a side airbag assembly with
the deployed airbag.
RS-47