BE-48
Engine Coolant Temperature
Gauge
I g ni t i o n
,
,--�� /e
Swi t c h
L
. 7
I
Battery
Engi n e Cool a nt
mpe
t
T
e
ra
u r
-
Battery
BODY
ELECTRICAL -
7.
Measure the resistance between terminals 2 and 3 for each
float position.
111639
If resistance value is not as specified, replace the sender
gauge.
If resistance value is as specified, replace the combination me
ter.
8.
(a)
Turn the ignition switch ON, check that the receiver gauge
(b)
Sender
Gauge
Nl7200
e gauge
(c)
Ground terminal of the wire harness side connector
through a 3.4 W test bulb.
Test
( 3 . 4 W)
Turn the ignition switch ON, check that the bulb lights up
(d)
-;:_
and the receiver gauge needle moves toward the hot
<'
Bulb
side.
lf operation is not as specified, inspect the sender gauge.
Then recheck the system.
METER
COMBINATION
INSPECT FUEL SENDER GAUGE RESISTANCE
Float
position:
(in.)
mm
1/2: Approx. 17.2 {0.68)
Approx.
E:
50.8 (2.00)
INSPECT ENGINE COOLANT TEMPERATURE RE
CEIVER GAUGE OPERATION
Disconnect the connector from the sender gauge.
needle indicates COOL .
(Q)
Resis1anc<J
Approx.
3.0
Approx. 31.6
pr o x.
A
110.0