Install Cylinder End Stopper; Air Tightness Test; Install Control Valve Assembly; Install Rack Housing Cap - Toyota Celica 2000 Repair Manual

N
N
N
�
STEERING POWER STEERING
INSTALL OIL SEAL
4.
Coat a new oil seat lip with power steering fluid.
(a)
To prevent all seal lip damage, wind vinyl tape on the
(b)
steering rack end, and apply power steering fluid.
Install the oil seat by pushing it into the rack housing with­
(c)
out tilting.
NOTICE:
•
Make sure that the oil seal is installed facing in the
correct direction.
Be careful not to damage the oil seal lip.
5.

INSTALL CYLINDER END STOPPER

(a) Using SST and a hammer, drive in the cylinder end stop­
per.
SST 09612-2201 1
Using snap ring pliers, install a new snap ring to the rack
(b)
housing.
6.

AIR TIGHTNESS TEST

{a) Install SST to the rack housing.
SST 09631-12071
(b) Apply 53 kPa (400 mmHg, 15.75 " 1 n.Hg) of vacuum for
about 30 seconds.
(c) Check that there is no change in the vacuum.
If there is a change in the vacuum, check the installation of the
oil seals.
7.

INSTALL CONTROL VALVE ASSEMBLY

NOTICE:
Be careful not to damage the teflon rings and oil seal lips.
8.

INSTALL RACK HOUSING CAP

(a) Coat a new 0-ring with power steering fluid, and install
it to the rack housing cap.
Install the rack housing cap.
(b)
Torque: 74 N-m (750 kgf-cm,
INSTALL RACK GUIDE SUB-ASSEMBLY, CONICAL
9.
SPRING WASHER AND RACK GUIDE SPRING CAP
Install the rack guide sub-assembly and conical spring
(a)
washer.
G!::- A H
54
ft-lbf)
SR-47