Toyota Celica 2000 Repair Manual page 1040

\, \
\, \
\ ___
;
__
_
Out side
_ __ ___
t
_
.-Fron! -
--·
2
Clips
'-
--
p
SOOY
REMOVE REAR SEAT OUTER BELT FLOOR AN­
10.
CHORS
HINT:
At the time of installation, please refer to the following item.
Install the rear seat outer belt floor anchor as shown in the il·
lustration.
Torque: 43 N.m (440 kgf.cm, 32 fl·lbf)
REMOVE QUARTER TRIM PANEL
1 1 .
Using
(a)
HINT:
Tape the screwdriver tip before use.
Employ the same manner described above to the other
(b)
side.
1 2 . REMOVE FRONT SEAT OUTER BELT SHOULDER AN­
CHOR
Torque: 43 N-m {440 kgf-cm, 32 ft·lbf)
13. REMOVE ROOF SIDE INNER GARNISH
Using a screwdriver, open the cap of coat hook.
(a)
HINT:
Tape the screwdriver tip before use.
Remove the screw and coat hook.
(b)
Using a screwdriver, remove the roof side inner quarter.
(c)
HINT:
Tape the screwdriver tip before use.
Employ the same manner described above to the other
(d)
side.
- -
REMOVE FRONT PILLAR GARNISH
- - - - 14.
- -
Using a screwdriver, remove the front pillar garnish.
(a)
HINT:
Tape the screwdriver tip before use.
Employ the same manner described above to the other
(b)
side.
REMOVE COWL SIDE TRIMS
15.
REMOVE FRONT DOOR OPENING TRIMS
16.
-
fiOOF
HEAOLINING
a screwdriver, remove the quarter trim panel.
BO-S9