Toyota Celica 2000 Repair Manual page 556

N
-
SUSPENSION AND AXlE
5. LOOSEN 2 NUTS ON LOWER SIDE OF SHOCK AB­
SORBER
Torque: 153 N.m {1,560 kgf.cm,
HINT:
Do not remove the 2 bolts and nuts.
6. DISCONNECT TIE ROD E N D FROM STEERING
KNUCKLE
Remove the cotter pin and nut.
(a)
Torque: 49 N. m (500 kgf.cm, 36 ft.lbf)
HINT.
At the time of installation, if the holes for a new cotter pin are not
aligned, tighten the nut further up to 60°.
Using SST, disconnect the tie rod end from the steering
(b)
knuckle.
SST
DISCONNECT LOWER SUSPENSION ARM FROM
7.
LOWER BALL JOINT
Remove the 2 nuts and bolt.
Torque: 142 N·m (1,450 kgf.cm, 105 ft.lbt)
REMOVE STEERING KNUCKLE WITH AXLE HUB
B.
Remove the 2 bolts and nuts on the lower side of the
(a)
shock absorber.
HINT:
At the time of installation, coat the nut's thread with engine oil.
Remove the steering knuckle with the axle hub.
(b)
NOTICE:
Be careful not to damage the boot and ABS speed sensor
rotor.
AXLE HUB
FRONT
09610-20012
SA-13
ft·lbf)
1 1 3