Toyota Celica 2000 Repair Manual page 436

MANUAL TRANSAXLE
3.
(a)
_ _
(b)
HINT:
T ake care not to damage the journal surface of the input shaft
4.
5.
""'"" , . - , _ . c .
(a)
(b)
(c)
(d)
NOTICE:
Distinguish the No. 2 synchronizer ring (for the 4th gear} by
the teeth on the synchronizer ring.
(e)
NOTICE:
Be sure to install the center radial ball bearing in the cor�
rect direction, as shown i n the illustration.
HINT:
Set SST to the bearing inner race securely.
000�%
.>-
· __
INPUT SHAFT
INSTALL SNAP RING
Select a snap ring from the table below that will make the
thrust clearance of the No. 2 clutch hub less than 0.1 mm
(0.0039 in.) .
Mark
Thickness mm
(in.)
2.30 (0 0906)
1 2.36 (0.0929)
2 2.42 (0.0953)
Using a screwdriver and hammer, ta p in the snap rin g
INSPECT 3RD GEAR THRUST CLEARANCE
(See page MX-30)
INSTALL SPACER, NEEDLE ROLLER BEARING,
NO. 2 SYNCHRONIZER RING (FOR 4TH GEAR), 4TH
GEAR AND CENTER RADIAL BALL BEARING
Instal! the spacer.
Apply gear oil to the needle roller bearings and install it
Place the No. 2 synchronizer ring (for the 4th gear) on the
No. 2 hub sleeve assembly and align the No. 2 synchro­
nizer ring slots with the No. 2 shifting keys.
Install the 4th gear.
Using SST and a press, install the center radial baH bear­
ing.
SST 09608-00071
MX-35
Thickness mm (in.)
Mark
2.48 (0.0976)
2.54 (0.1000)
5 2.60 {0.1024)