Toyota Celica 2000 Repair Manual page 572

SUSPENSION AND AXLE -
Mat c hmar k s
Ff10N f DRIVE SHAH
Assemble the outboard joint shaft.
(b)
Install the cage to the outboard joint shalt.
( 1 )
NOTICE:
The side with smaller diameter must face outboard joint.
Align the matchmarks on the inner race and out­
(2 )
board joint shaft
f103•
•B
Using a brass bar and hammer, tap in the inner race
{3)
to the outboard joint shaft.
NOTICE:
Be careful not to damage the inner race.
Using a snap ring expander, install a new snap ring.
(4)
Align the matchmarks on the cage and inner race.
(5)
Install the cage to the inner race.
(6 )
Install the 6 balls.
(7)
HINT:
Apply grease onto the balls to keep them from falling.
Install the boot to outboard joint.
(c)
Before assembling the boot, pack the outboard joint and
boot with grease in the boot kit.
Grease capacity: (Color = Black)
1 1 5 - 135 g (4.1 - 4.8 oz.)
Install the inboard joint shaft to outboard joint shaft.
(d)
Before assembling the boot, pack the inboard joint
( 1 )
and boot with grease in the boot kit.
Gre ase capacity: {Color = Gray)
100 - 120 g (3.5 - 4.2 oz.)
SA-29