BE-26
N
l 1 1.'>00
-
BODY ELECTRICAL
TURN SIGNAL AND HAZARD WARNING SYSTEM
INSPECTION
1.
INSPECT TURN SIGNAL SWITCH CONTINUITY
Switch position
lei! turn
Neutral
Ri ht tum
If continuity is not as specified, replace the switch.
11���
2.
INSPECT HAZARD WARNING SWITCH CONTINUITY
Condition
OF�
ON
!l!urnination circuit
If cont1nu1ty rs not as spectf1ed, replace the swttch.
114192
3.
INSPECT TURN SIGNAL FLASHER OPERATION
Connect the positive (+) lead from the battery to terminal
(a}
2 and the negative {-) lead to terminal 3.
Connect the 2 turn signal light bulbs parallel to each other
(b}
to terminals 1 and 3, check that the bulbs flash.
HINT:
•
The turn signal lights should flash 60 or 120 times per min
ute.
•
llEIB-43
If one of the front or rear turn signal lights has an open cir
cuit, the number of flashers will be more than 140 per min
ute.
If operation is not as specified, replace the flasher.
T ester connection
Specified condition
1 - 2
Contini.II\y
No continuity
2 - 3
Conlinui
Tester connection
Specified oor1d�ion
5 - 7
Continuity
5 - 6.
Continuity
1 - 2 - 4
8 - 9
Continuity
.
.