Toyota Celica 2000 Repair Manual page 573

SA-30
Matchmarks
SUSPENSION AND AXLE
---/
)- -
�" - - - -
(2)
{3)
-
{4)
(5)
Assemble the boot clamps to both boots.
(e)
( 1 )
(2)
Drive shaft standard length:
(3)
(4)
(5)
SST
(6)
NOTICE:
Do not overtighten the SST.
(7)
SST
Clearance: 1 . 2 - 4.0 mm (0.047 - 0.157 in.)
(8)
-
DRIVE
FHONT SHAFT
Align the matchmarks on the inboard joint shaft and
outboard joint shaft.
Install the inboard joint shaft to the outboard joint
shaft.
Instal! a new snap ring.
Temporarily install the boot to the inboard joint
shaft.
Make sure that the boots are o n the shaft grooves.
Make sure that the boots are not stretched or con­
tracted when the drive shaft is at standard length.
:t
RH 845.5
+
LH 563.7
Bend the band and lock the Inboard JOint boot
clamps with a screwdriver.
Secure the 2 outboard joint boot clamps onto the
boot.
Place SST onto the outboard joint large boot clamp.
09521-24010
Tighten the SST so that the large clamp is pinched.
Using SST, adjust the clearance of the large clamp.
0924(}-00020
Employ the same manner to the outboard joint
small boot clamp.
5.0 mm (33.287 ±: 0.197 in.)
+
5.0 mm (22.193 0.197 in.)