AUTOMATIC TRANSAXLE (U341E)
INSTALLATION
1.
Using calipers and a straight edge, measure the distance be
tween the installed surface and the front surface of the trans
axle housing,
2.
Installation is in the reverse order of removal (See page
AX-31).
HINT:
•
�
AUTOMATIC
TRANSAXLE
CHECK TORQUE CONVERTER CLUTCH INSTALLA-
TION
Correct distance: More than 13.3 mm (0.524 in.}
TRANSAXLE INSTALLATION
After installation, adjust the shift control cable and park/
neutral position switch (See page 01-220).
Fill ATF and check the fluid level (See page 01-220).
Perform the test drive ot the vehicle.
Adjust the hood ( See page 80--9).
UNIT
AX-35